- Cold weather sealing
When you need to do some sealing on a crisp, cool day keep your sealant pliable and running smoothly by wrapping the tubes in a heating pad (like those sold for pain relief) for 30-45 minutes before using them. Trap the heat by wrapping each tube in plastic wrap before inserting it into the sealant gun.
- Clean fingers
Don’t use your finger to shape a bead of silicone sealant around a bath or basin (unless you don’t mind wearing it for a while). Instead, use a lollipop stick or the back of an old plastic teaspoon; both have smooth, rounded edges and are easy to hold, so you can avoid getting silicone on your skin.
- Improve your aim
It can be hard to manoeuvre a sealant gun in a tight spot or to properly seal a crevice that’s out of reach, but an effective extension tool may be as near as the kitchen drawer: a plastic drinking straw. Push the straw (or any plastic tube of the right size) into the nozzle of the sealant tube. Keep your impromptu extender from slipping off by securing it with gaffer tape.
- Mix it up
Old jam jar lids are ideal for mixing two-part epoxy adhesive. The raised edge keeps the adhesive from spreading out as you’re mixing it, and the limited interior space prevents you from using too much.
- In the bag
If you are looking for an easy way to mix and apply two-part epoxy adhesive there’s a solution in the pantry. Take a plastic sandwich bag and squeeze as much adhesive as you need into a corner section. Tie off the rest of the bag and mix the epoxy by rolling it between your fingers (You’ll notice the adhesive gets warm as it is mixed.) Use a pin to put one or more small holes in the bag and gently squeeze the epoxy adhesive out.
- Unglue the glue
You shouldn’t have to fight to get adhesive out of a bottle or tube. Dab a little petroleum jelly on the inside of the lid or on the tip of the tube before replacing the cap. It will prevent the glue from sticking to the cover, and you will have one less frustration to face.