- White-out wall and ceiling flaws
A small bottle of white correction fluid such as Liquid Paper can be incredibly handy in more ways than one. What you may not know is that it’s even more useful around the home for covering up small stains and blemishes on white walls, mouldings and ceilings. Simply dab it on the defect, and it’s gone. When touching up glossy surfaces, coat the dried correction fluid with a little clear nail polish.
- Fix small cracks
Don’t repaint a ceiling expecting to cover up a few small cracks. Hairline cracks need to be checked and repaired. Use a utility knife to open up the cracks, brushing away all dust. Fill with quality plaster filler and then smooth over the patch with 180-grit abrasive paper before sealing and painting.
- Wipe away wallpaper paste
Removing old wallpaper can be a pain, but what’s even worse is contending with old wallpaper paste. A window squeegee can make the job a lot easier and neater. Dip the squeegee into a bucket of very hot water; add 1 cup (250ml) vinegar for extra-strength paste. Use the spongy side to apply the solution to the wall; then flip it over and use the blade to remove the glue. Then wipe the glue off the blade frequently with a damp rag.
- Cover nail holes without filler
If you run out of filler, take a look in your bathroom before heading off to a hardware shop. A little bit of plain white toothpaste should do the job. You can also fill small holes in plasterboard with a paste of equal parts of bicarbonate of soda and woodworking adhesive. Or you could mix 2 tablespoons salt and 2 tablespoons cornflour with just enough water to make stiff putty.
- Stick on a patch
Some people think that the lack of wall studs makes it far more difficult to patch a hole in plasterboard. But they’re wrong. In fact, all that’s needed is a couple of thin slats of timber about 25mm wide, manoeuvred through the hole and held in place against the back of the plasterboard by a combination of cornice adhesive and plasterboard screws. A piece of string tied through a hole in the middle will prevent you losing the timber slats down the wall. Once the slats are in place, a matching plasterboard patch can be stuck or screwed in place and damage made good with wall filler.
- Find a wall stud with a shaver
If you don’t have an electronic stud finder, use an electric shaver instead. Switch on the shaver and place it flush against the wall. Move it slowly over the wall, and note the sound of its hum. When the shaver moves over a stud, the pitch of the buzz will rise.
- Secure a screw
A screw set into a wall without a plastic plug may work loose over time as the hole surrounding it expands. Take up the slack by cutting one or two twist ties into strips that are equal in length to the screw. Bunch them together in your fingers, stuff the hole and then reset the screw. If the hole has significantly widened, opt for oversized plastic plugs in masonry walls to match or toggle bolts in plasterboard walls.
- Banish ceiling stains
Get rid of ugly ceiling stains by putting on a pair of gloves and goggles, then aiming a long-handled sponge mop moistened with equal parts water and sugar soap at the ceiling. Simply scrub until the stains are gone.
- Match a patch
When repairing damaged textured coating on a section of ceiling, it’s worth putting in the extra effort to do the job properly. Once the coating is level, try to match the texture of the surrounding ceiling. You can usually come pretty close by applying some gentle touches with a small scrubbing brush, a pocket comb or a dry abrasive sponge.